I just installed a Rotopixel Gimbal on my Phantom 2 Vision. I got it second hand so it did come with paperwork. There is a "reset" button on backside of the board. How is it used to set it up? Right now its not "level" from side to side, other then that it works great. I do have it balanced.

Could be a software setting adjustment.  I haven't had that problem, but some of the comments and replies below this video may help.



One thing I did when I fitted mine was to flip the plate on the bottom of Phantom body and fit longer legs.  This gets the camera further away from the props and also helps prevent jellow effect as the rotorpixel plate is too tight to the Phantom in my opinion.

http://forum.dji.com/forum.php?m ... amp;page=1#pid71891

Hope it helps.

In addition this video gives you setting adjustments at 1.10