Hi all. Been flying about 2 weeks. Finally loaded Assistant software for PC to set up and swtiched to Naza model to enable IOS functions. When done IOS works fine, but gimbal is hinky. I can elevate or depress the camera (to look forward or down) when using my iphone as controller, but not when using the dial on the top left of the new controller. I've looked at the RC tab under Basic widgit and it seems like the X1 channel is implicated in this but I can't figure out what to do. It seems clear that the motors on the gimbal are working fine as it performs when controled from the phone just not from the controllelr (which is SO much easier.)
Yup - and sorry - I did an initial search to see if there was a known/fixed problem but didn't find the entry. while waiting for a response I upgraded my search terms and viola! found how to do a stand alone calibration. Seems to be working now. Gonna go fly just to make sure. And, because I can. Thanks and sorry for any bother.
New
lvl.2
- I did an initial search to see if there was a known/fixed problem but didn't find the entry. while waiting for a response I upgraded my search terms and viola! found how to do a stand alone calibration. Seems to be working now. Gonna go fly just to make sure. And, because I can. Thanks and sorry for any bother.