Hi. I live in Colombia and I bought in jun 16 2015 order 549253750 and in may 19 2015 order 544606700 in New York, store BH Photovideo  a: DJI S1000+/A2/z15-a7 KIT and DJI lightbridge 2.4GHZ Full HD VID DWNL/Glases
1- Spreading Wings S1000+
2- A2 Flight Control System serial CG221919366532
3- Zenmuse Z15-A7 Gimbal serial CG201850091567
4- LightBridge 2.4GHZ Full HD VIDEO Serial CE161941298400
5- Zeiss (J1) Carls Zeiss Cinemizer Glasse Serial H510C0024
6- DJI Dropsafe Serial BK271256366683
7- Futaba 14SGH Radio 2.4 GHZ for Helicopter MD2

I get the items in august 2015 and I try to arm the components and could not do it right. but I had a healt problems in september so I leave my drone and I start again 15 days ago. Please help me to arm my Drone. Isee to many manuals an learnings from you but most of them are confuse.

I´m going to tell you what I have set up:

1- I already have setup all Spring Wings Parts
2- The IMU is conected to the CAM 1 in the A2 Flight Controller and to GPS like you see in 1picture and 1Apicture
3- The GPS is conected to the XT60 energy in the top whit the Air System power and Cam cable like you see in 2picture. The cable end (see 4picture) go to GPS. I don´t know what to do whit the this cable end see 3picture.
4- PMU is conected to the other XT60 energy in top
5- PMU (PW) is conected to A2 fligth controller CAM 2
6- PMU (X1) is conected to X1 in Flight Controller (BUT WHEN IS CONECTED MOTORS 1 TO 4 ARE NOT LIGHTING)
7- LED-BT-I unit is conected to PMU see 5picture
8- M1 to M8 in Flight Controller is conected to ESCs in Spreading Wings whit the each 3 pin cables
9- Landing Gear Left Servo to Left Servo Connector see picture 7
10- Landing gear Right Servo to Servo Connector see picture 7
11- IN port in in the landing gear control Board to F1 in Flight Controller see picture 7
12- Landing Gear and Zenmuse are conected to XT60 down port
13- X2 in Fligth Controller to DBUS in Lghtbridge
14- Gimbal Port in Lightbridge to G7 Port in GCU
15- Motor input port in Gimbal to G6 Port of GCU (there are 2 ports for Motor input in Gimbal. which one I get?
17- 9-pin port to G9 Port of GCU

Tell me What Im Missing? What is wron? why when I connect the PMU (X1) to X1 in Flight Controller the motors 1 to 4 not lighting?

I know after I finish whit that I need to work in the set up between Air and Ground if you can give me a good information to set that too I appreciate.

I dont see any pictures