Hi all,

Found another problem with follow mode, the camera locks at one possition like it should, but after some time it moves and locks at another position, is that a bug or is it just me?

Can you tell more details?

Have you examine the position of the yaw(on outer of the radar, one blue circle that indicates the position of yaw, the blue circle begins from the middle of the radar and end at the red circle. Pan the yaw of gimbal you will see how the blue circle moves.)?

If the gimbal hit the limit of yaw, it will lock at the new direction.

DJI-ZT Posted at 2015-1-9 23:23
Can you tell more details?

Have you examine the position of the yaw(on outer of the radar, one blue ...

I was in the impression that the Inspire did not have a Follow Me feature at this time

DJI-ZT Posted at 2015-1-9 23:23
Can you tell more details?

Have you examine the position of the yaw(on outer of the radar, one blue ...

Ahh i see, i hit the yaw limit.

I see the camera rotates to about 720 degres or 2 circles, why cant the camera roate to infinity, is it a hardware challange to produce?

I thought that the camera can rotate to infinity on yaw axis.

Ozren Posted at 2015-1-10 00:16
Ahh i see, i hit the yaw limit.

I see the camera rotates to about 720 degres or 2 circles, why ca ...

You are limited to 320 degrees on each rotation.  The gimbal does not rotate freely 360 degrees.

Hardware challenge to design.
Too many wires!

DJI-ZT Posted at 2015-1-10 01:36
Hardware challenge to design.
Too many wires!

I thought so ;) 20 wires with mercury connector at that size is impossible, at least for now.

Thanks for response

pidetectives@ya Posted at 2015-1-9 23:46
I was in the impression that the Inspire did not have a Follow Me feature at this time

this is not the follow me feature, it is the lock feature that the camera will lock on the orientation no matter how the craft maneuvers.