Hi all, I purchased the DJI P3 HDMI adapter board and installed it into my new P4 RC and it updated the Firmware when I turned it on and the Nice clean HDMI output was displayed on my smart TV via its HDMI input port.

It just works!

Best regards,
Steve

Teaser? Post a short video, and share the utmost joy... ;-)

RedHotPoker

Really, I have an email response from asking DJI technical support and they stated it was not compatible with P4 ?
This is good to know, Hope it does not cause any flight problems if not fully tested.

Good to know.  I was wondering about how the firmware updates.  I have a module in the box, just 3 more days 'till the P4 arrives.

Yep, it will work, just make sure you update your P4 and RC with the latest Firmware posted this week by DJI, then install the HDMI module and it will inform you of the HDMI update available, follow it and your done!

It's really works and No issues flying or other!

Best regards,
Steve