pcm2a
lvl.1
United States
Offline
|
So back at home here is what I did, about 25 times so far....
1. Hold reset button on side of wifi repeater until the system light goes out
2. Wait and eventually I can connect my phone to the Phantom wifi
3. Start the DJI app and pick to bind
4. Scan QR code doesn't work, it's too small on the camera (no retail box)
5. Type in the last 6 digits below the QR code, says binding successful
6. Power off EVERYTHING, power on everything
7. Phantom wifi shows up for a few seconds then goes away
8. Phantom wifi never comes back, even after many resets
9. Hold in the reset button and go back to step 1.
10. Dead in the water...
I suspect I have an expensive paperweight unless I can figure out how to get the camera's mac address. I have no box. There is an unscannable QR code on the camera. There are numbers under it and the last 6 must not be the mac address.
|
|