When I added the mount and rods (http://store.dji.com/product/15mm-rod-set), the lens support is no longer mountable.

The problem is that the screw that came with the lens support is not long enough when the mount and rods are attached.  This seems like a simple one.

Any ideas?

Mark

Could it be that I need this:

http://www.bhphotovideo.com/c/pr ... rt_thumb_screw.html

Mark

medavidson Posted at 2016-3-19 21:40
Could it be that I need this:

http://www.bhphotovideo.com/c/product/1070614-REG/dji_cp_zm_000098_le ...

I made my own FF rod for my Dji focus on a lathe, $70 is quite expensive for that thing.

valealvarez.s96 Posted at 2016-3-21 01:58
I made my own FF rod for my Dji focus on a lathe, $70 is quite expensive for that thing.

Im past the expensive part, now I need to get to the solution part.  This seems not only a simple fix, but one the engineers at DJI must have considered.

I can't find anything on it anywhere.

medavidson Posted at 2016-3-22 07:06
Im past the expensive part, now I need to get to the solution part.  This seems not only a simple  ...

Just drill it a few milimiters and then you are good with the screw, you can use sand paper too, it's aluminium, easy to work with

This issue will be reported to our relevant Dept. for review. Thanks for your feedback!