Hello. Does any one have the settings for a dx6i to naza m v2? I am using a spectrum ar 600.

These was the settings I was given,
Naza n GPS settings for dx6i

Travel Adj
Thro - 100% Aile – 100%
Elev – 100% Rudd – 100%
Gear – 40% (SW =0) Flap – 100%
Gear – 80% (SW=1)

Flaps
Norm – 100%
Land – 100%

Mix 1
Flap -> Gear Act
Rate Down+ 100% Up – 0%
SW – On Trim INH

Gear/Flap swtch Modes
0 0 Manual mode
1 0 Atti mode
1 1 GPS Hold mode
0 1 RTH (panic switch) 

didn't use them I went by a you tube video.
Will see if I can find it.

It won't let me post a you tube video.

Google it, dx6i naza m v2 videos and it was by phoebehndz.

Was it the brittish guy? I got all switches to line up correctly  in the software. buy have yet to get it to spool up. I get an error 27 every time I connect via usb.

Have you ran the motor test to see if all motors are going in the correct direction?
You can't spool up while the USB is plugged in.
Have you gone through the start up procedure with two sticks on the transmitter?

Error 27 is the compass has not calibrated correctly.

http://www.djiguys.com/Forum/viewtopic.php?f=4&t=38

thanks for the help guys. I flew for the first time tonight. This thing is crazy stable compared to my 350 qx.

can anyone help me with a f550 with naza, solfware