This happened on my Phantom 2 v2.0. I fly this with a Zenmuse, GoPro & FPV.
Over time, the antenna wire wore through the protective layer on the central circuit board (see pics below).
This happened while I was flying, my Phantom lost all GPS satellites and became hard to fly. While I was trying to land it, I noticed the rear lights were solid red. Swapped out many parts before noticing the circuit board had what appeared to be an electrical burnt area.
I was able to swap parts from an older Phantom 2 and that's how I confirmed the problem. I did put a piece of electrical tape and I noticed the other board had a DJI sticker right where the wear point is. |