Is there a way to disappear these strip lines in video comming from Zenmuse H3-2D?

Is it from the monitor or the SD card?

No it is from video comming from the gimbal. If I connect the camera straight to my transmitter from it's USB port these lines does not exist. Only when I connect the gimbal's video signal are these lines apearing.

Here is the video:

and here other users having the same issue too: http://www.rcgroups.com/forums/s ... ge=287#post26995761

kosmas Posted at 2014-9-28 18:56
No it is from video comming from the gimbal. If I connect the camera straight to my transmitter from ...

This is a pretty common characteristic of the H3-2D gimbal.
Most of us just live with the lines because they are not on the recorded video.
The interference is caused by the H3-2D to gimbal connections.
If yours is so bad that you can't stand it, contact the DJI Service Center...

In Greece.........ok ok anyway I will stand with it....understood

Parts of the DJI site are down right now, or I'd post a link.
DJI Germany, I believe, would be your contact...