Please select Into the mobile phone version | Continue to access the computer ver.
Ronin-M: Lens Support obstructing Roll Axis lock-knobs
1119 5 2016-3-26
Uploading and Loding Picture ...(0/1)
o(^-^)o
pbt04
lvl.2

Ghana
Offline



We have a 5D Mk III body and a Canon 24-70mm Mk II lens on the Ronin-M gimbal


The lens support fits nice and snugly against the smooth surface on the lens (the area between the zoom and focus rings)


The problem we are facing is that the two red, metallic lock-knobs for the Roll Axis cannot be turned 360 degrees because they are obstructed by the bottom part of the lens support - this means we cannot properly tighten these knobs to stop the camera moving side-to-side


We have this issue whether the lens support is facing inwards or outwards, and as for the mounting plate, we've tried both of the two holes at the back of the platform


Has anyone had a similar experience?


Thanks!
2016-3-26
Use props
DJI-Adela
DJI team

Hong Kong
Offline

Hello!
Thanks for your feedback!
Could you please show us the picture? If it's possible to improve, we'll try to do that in the future update.
2016-3-28
Use props
pbt04
lvl.2

Ghana
Offline

DJI-Adela Posted at 2016-3-28 10:36
Hello!
Thanks for your feedback!
Could you please show us the picture? If it's possible to improve,  ...

Please check out the two images I have uploaded to Dropbox

As you can see, in this configuration, with the camera and lens roughly stabilised, the lock-knobs for the roll axis cannot be fully tightened

https://tinyurl.com/zfd746u
2016-4-1
Use props
noipego
lvl.4
Greece
Offline

pbt04 Posted at 2016-4-1 18:48
Please check out the two images I have uploaded to Dropbox

As you can see, in this configuration, ...

yes same issue with 16-35L ..i have to remove the support, then slide, then replace the support, then check balance...over and over again before balanced..
2016-4-18
Use props
pithaaa
New

Georgia
Offline

The same prolem when using Canon 5D Mark III and 24-105 f4 lens
2016-4-20
Use props
DJI-Adela
DJI team

Hong Kong
Offline

pbt04 Posted at 2016-4-1 23:48
Please check out the two images I have uploaded to Dropbox

As you can see, in this configuration, ...

Sorry for the inconvenience!
In this situation, please use a hexagonal screwdriver to adjust the tightness of the screws within the two red knob and then you don't have to twist the knob too far to tighten the positions.

Thanks for your feedback!
2016-4-21
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules