precisionair
lvl.3
Flight distance : 1594 ft
United States
Offline
|
Donnie or community can you please guide me in this issue?
Here are details:
Updated RC Master using DJI GO App to most recent firmware. App read back update complete, restart RC.
I restarted RC, no more communication with Ipad, no communication with craft, steady red light, no beeping.
I updated the Slave RC in the same manner, restarted RC, and it works fine. I changed it over to Master, controls craft fine.
Craft and Slave updates are clean, all batteries are clean.
Primary master remote is still steady red light at this point. Will not communicate with Ipad or Android phone. Attempted 3 genuine ipad cables, all same results. Attempted to reset the RC using instructions you provided by pressing the 4 buttons and restarting. While holding the buttons and restarting the RC it makes one beep pattern in the very beginning and continues to sit on a red light. If I hit the 4 buttons while the RC is on, not during startup, I get a very angry beep and blinking blue light. Not a stead blue light or the normal beep pattern, just a steady one 'D---D---D---D---D", I have let this go on for 30 minutes, no change. II restart the RC and attempt communication, I get nothing. I restart with a USB stick and old firmware, no beep pattern, no light changes. The only change I get when attempting to do USB stick update is the "inactivity" beep. Concerned at this point that my USB is busted, going to attempt to swap USB from my working RC to non-working RC and see what happens. Any suggestions would be helpful!
Brad |
|