Does anyone else have problems with their two grips on the handle bar not tightening? I have had this issue ever since I got it, but had to put off sending it in because of jobs already set.
DJI seal on the box was never broken when sent in. I seem to have two left handed grips rather than one for each side.

Anyone out there experiencing the same problems?

BUMMED

Bobby

did you tightenned the screws of the handles with alem keys? if they are not flesh to the surface the handles will not tighten. check for that

If you install the two grips correctly, they should be symmetrical. You can also check the screws in the two grips, the directions of the two screws are just opposite.

In my case, it's the carbon fiber rods. Even screwed in the top handle, they get loose over time. -_-