Hi I have a problem with the gimble on my Phantom Vision + V3 whenever I’m flying the gimble slowly drops down to point at the floor I then bring it up using the wheel on the controller but it just drops again. Any ideas or solutions,   Please.

Try recalibrating the Gimbal in the Assistant Software.

You didn't mention. Has this been like this from the beginning? Did you have a crash? I asume you've callibrated your gimbal and transmitter accordingly?

Also Check out:
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en
http://forum.dji.com/forum.php?m ... =gimbal&lang=en

mmmh, quite a few post recently concerning problems with the Vision gimbal with wheel on transmitter.

Make sure the gyro icon on the left side of the Vision App on your phone is not enabled (blue). If it is the gimbal tilt will follow your phones movement up and down.

Many thanks. Ill have a look at that button next time I go out  Trouble is that I'm 75 with shaky hands so don't like to mess with fiddly setting not when they have been set by the manufacturer who should know what they are doing (no tongue in cheek) I haven't crashed at all except it did tilt on landing one time and the props were slightly scuffed. Many thanks for the reply's.