Hi Hall after rc update GL300A via tablet, always comes the error message RC Signal Lost, the gimbal works but does not arming.
I tried to do the RC back links and over again, but nothing to do.
Do you have any idea?
Thank you

Have you updated the aircraft firmware too?  What versions is it showing in the GO APP?

ralcock Posted at 2016-4-13 21:13
Have you updated the aircraft firmware too?  What versions is it showing in the GO APP?

Yes i update first aircraft, DJI GO IOS version 2.7.1

dimgio@inwind.i Posted at 2016-4-13 20:17
Yes i update first aircraft, DJI GO IOS version 2.7.1

Check whether the GO APP is displaying the versions of FW & RC you think it should be.  I am 2.7.1 with FW 1.8.80 RC 1.6.0. this is what yours should be displaying if you have just updated the latest versions

ralcock Posted at 2016-4-13 21:24
Check whether the GO APP is displaying the versions of FW & RC you think it should be.  I am 2.7.1 ...

About the only show in the DJI Go version
RC and Aircraft  nothing

dimgio@inwind.i Posted at 2016-4-13 20:45
About the only show in the DJI Go version
RC and Aircraft  nothing

sorry? are you saying that its showing nothing for aircraft & RC? if that's the case you will need to run the update for both again!  Update aircraft first then RC through the GO APP.  Remember you MUST delete the previous BIN file off the SD card before adding the latest BIN file.  Good luck

Hello, I'd suggest you to upgrade your drone again and reinstall the app again. Normally if the upgrade result is success, you can see the drone and rc version clearly in About with them on.

dimgio@inwind.i Posted at 2016-4-13 15:45
About the only show in the DJI Go version
RC and Aircraft  nothing

stupid question here but did you have the drone powered up and tablet hooked up the the rc as if you were going to fly?

I just had the same issue today and it ruined my day. Have you guys tried to Downgrade it to the Preview Firmware ?

RC SIGNAL LOST after my P3 Professional upgraded to Go App V2.7.2 (iOS)  
DOWNLOAD   Phantom 3 Professional Firmware v1.8.80 (2016-04-07) Unzip file, copy BIN file to SD card (format) than insert to aircraft ( full Battery Charged) upgrade the  aircraft (15-30 minutes)
Its work for me
NO MORE ISSUES

P3P: Last Status
App v2.7.2
Aircraft v1.8.80
RC v1.6.0