tomb18
New
Canada
Offline
|
So, I have a Naza V2 flight controller and I bought a Mini OSD controller. I hooked it all up and there was no output of OSD data. So I did an RMA but to save time I bought another one.
Guess what, same thing! So I sent it back, and DJI returned both of them after 3 months, both of them under warantee repair. But only after I complained.
Guess what, both do not work!
So what is going on? I am using the latest firmware, on the Naza, I am using a ready made RC NTSC camera. I have tried two different monitors and never any OSD.
Is there something I have to enable in the firmware? What is going on?
I have done searches and I have found many threads where the OSD's were not working. RMA usually fixed this up.
Do I need to scrap the whole NAZA and move to a PixHalk?Please provide some support here instead of just having them sit on a shelf until I complain!!!
Help!
|
|