I have two of my 'own build' drones and currently use Lightbridge 1 and H4-4d gimbal s on both.
I really want to use the Lightbridge 2, but it doesnt seem to be compatable with the H3-3d or h4-3d gimbals? (please confirm)
Im trying to figure out a way to be able to use it?
What about if I used a different 3rd party gimbal such as the FeiyuTech gimabl for GoPro? I dont want to move away from the Zenmuse but DJI are giving me no option.
Hi,
Unfortunately, DJI Lightbridge 2 is not compatible with Naza V2 and the H3-SD/H4-3D Gimbal. If you use the Ground Station of Lightbright 2 with a 3rd party Gimbal, you may only control the Pitch of the Gimbal.
No.
The Remote Controller is now integrated into the Ground System, the integrated Ground system doesn't work with 3rd party Air system. With the A2 FC and a 3rd party gimbal, you can only control the pitch axis with the RC of Lightbridge 2.
PWM ports on front of my A3 do not output anything as far as I can tell.
I'm going through ASSISTANT2, TOOLS, FUNCTION CHANNELS to configure.
Do you guys have these ports live yet??
Like doug, I would like to control pitch on a third party gimbal through one of the ports 1 thru 8
I do get a slight pitch tilt downward when F2 is coupled with D1 thru 4 in Assistant 2 but no direct control with any of the dials or switches.
Non of the PWM outputs 1 thru 8 will drive a common finder HK Discovery buzzer.
Also not directly related but let your guys know to put this on the list - Hero4 blanks out HD fpv when set to record. Hero3 does not.
I'm reading on RC Groups that PWM 1 thru 8 is not implemented on the A3 and there is no timeline for it. This precludes any mapping to pitch function on a third party gimbal until DJI gets around to it. From past experience this could be anywhere between 2 weeks to 2 years (not kidding).
Hi, I want to connect N3 + LB2 to control my cable cam as it seems that LB2 has better signal than any other branded radio in the market. I am now in the middle of no where. I can power up both N3 + LB2 and give signal to ESC to control motor on Cable cam. However, the motor can only spin toward one direction and I can not control the motor to stop or direction reversed. Can anyone help?