I have a motor seasing up and want to replace it from another 3 Standard I have that quit working.  The4 screws that come with it have a wrench or hex.  The screws to the plastic body are different.  I can't change the motor without removing the plastic piece.  Can someone give me the try of screw wrench it takes to fit these screws?  I tried che chat and only got cut off each time.

The 4 motor screws take a 2.5mm hex driver.

DJI-Ken Posted at 2016-5-3 09:47
The 4 motor screws take a 2.5mm hex driver.

The aircraft came with that wrench.  I need the wrench that fits the other screws in the plastic that start beside the 4 you mentioned

tricks46 Posted at 2016-5-3 23:44
The aircraft came with that wrench.  I need the wrench that fits the other screws in the plastic t ...

Those take Torx drivers. I think the 3 inside ones are T9 and not sure on the size of the inner 1. Just purchase a set and you'll get all of them.

DJI-Ken Posted at 2016-5-3 11:26
Those take Torx drivers. I think the 3 inside ones are T9 and not sure on the size of the inner 1. ...

Sounds good are these sold here?

tricks46 Posted at 2016-5-4 00:43
Sounds good are these sold here?

You can get them from any hardware store.