Hi, my P3S ran into a tree tonight while returning to home. Long story short the worst damage is the ribbon wires from the gimbal to the drone came out of the connector thing on the gimbal. How do I fix this?? I've tried putting them back in but I can't get them to stay, any help would be appreciatedv thanks.

Hello prestonk24, unfortunately the cables for phantom 3 standard are not available. I'd suggest you to contact our North American service center for repairing as below:
Email: support.us@dji.com
Phone: +1 (818) 235 0789  
Mon-Fri 9:00 am - 5:00 pm (PST)

DJI-Paladin Posted at 2016-5-5 22:28
Hello prestonk24, unfortunately the cables for phantom 3 standard are not available. I'd suggest you ...

I think you misunderstood my problem, the wires are fine. The only problem is they're not connected to the gimbal itself. How do i get the wires to fit back into the little connector that plugs into the gimbal on the front??

Normally it should be like this. But if the lines are seperated from the connector, it is recommended to change a new cable.

do you mean the black ribbon cable or the grey multi-wire cable as pictured above

Shaun_au Posted at 2016-5-5 23:40
do you mean the black ribbon cable or the grey multi-wire cable as pictured above

On my P3S its the grey ones then theres 2 more wires one black and one grey that do onto the board but came off.

prestonk25 Posted at 2016-5-6 08:12
On my P3S its the grey ones then theres 2 more wires one black and one grey that do onto the board  ...

Oops! Well, that could be another problem.