hey all, my new Pro Black Edition came with 1.4 craft firmware,   is there a special link for the pro version X5 1.8 upgrade?
I installed the bin file on my sd card from the normal link I used for my old inspire 1 X3  and when I try the upgrade nothing happens on my pro,   blinking yellow led only?  Will not upgrade,  micro sd card is formatted, never had any issues upgrading firmware before for my Inspire 1 X3.

Where is the special link for the pro X5 version???

thanks,

Scott

Inspire PRO/RAW Downloads

Pay attention as there are TWO aircraft supported from this page -> PRO & RAW...
Each has its own firmware as the cameras are different. Download the PRO firmware:

https://dl.djicdn.com/downloads/inspire_1_pro/WM610_FC550_FW_V01.08.01.00.zip

thank you Terry, I will try tonight

thanks,  worked like a charm!   

I have this same problem... but haven't got as far as re installing the right firmware yet. Do you have to wait for the battery to be dead before turning the Inspire Pro off??? Or can I turn it off even though it is flashing away? Been flashing for almost two hours and still got circa 75% battery left!!

Thanks in advance

if its flashing yellow for that length of time ,  I would have powered it off      should not be a problem

dentin11 Posted at 2016-5-28 19:16
if its flashing yellow for that length of time ,  I would have powered it off      should not be a p ...

Thanks - got fed up and went for it. haha All ok.

tprendergast Posted at 2016-5-31 11:53
Thanks - got fed up and went for it. haha All ok.

Sorry no one got to you sooner, it is tough to get to them all sometimes,   also if you ask an active member directly, you might get a quicker response.  

come back and pay it forward and stay active

cheers -donnie