lancerail.email
New
United States
Offline
|
Tonight I installed my FPV system and the H3-3D gimbal on my Phantom 2. When I first powered it on after the install, the gimbal went thru its self check routine and leveled itself out, as I assume it's supposed to. I then went into the assistant and did the recommended gimbal firmware update.
When I powered it on the next time, the gimbal sat limp...no noise...no movement.
I tried resetting the gimbal several times and reinstalled the updates, but nothing has corrected the problem.
Any suggestions or help for this Drone newbie?
Thanks,
Lance in Fort Worth
|
|