I can't get the motors to start when I put the sticks in CSC position. I have calibrated the sticks...done all the updates...I'm not in Beginner Mode....so I'm mystified. Thank you, in advance, for your time and advice.

Have you calibrated your compass and IMU?  What mode is your Tx in?

Yes to the first and second. I am in P mode.

I have finally had success...by putting the sticks, not in CLC position, but in the lower opposite corners.

That's wierd - out of interest which control mode (not flight mode) are you using?

Check your Master Stick Mode - it should be Mode 2.

RC Settings -> RC Control Settings -> Stick Mode

Yep....mode 2

Could you pls take a screenshot of the RC calibration page when you put the stick in CSC position?

Just a thought - Have you tried the "unlock the motors" option in the menu? I don't think that this feature is currently being used, or what it's really for...

DJI-Autumn Posted at 2015-1-26 10:47
Could you pls take a screenshot of the RC calibration page when you put the stick in CSC position?

Here you go:

neuroverse Posted at 2015-1-26 10:56
Just a thought - Have you tried the "unlock the motors" option in the menu? I don't think that this  ...

I will try that.....will let you know

I have followed all the suggestions given by you guys....and I thank you. But the craft still does not respond to CLC...however, the lower opposite corners work fine for engine start and stop...so go figure...otherwise the Inspire works great..

Pete, the value here should be both 100%. Seems your caliration was not successful.
Try more and I'll ask for more ideas

DJI-Autumn Posted at 2015-1-27 09:56
Pete, the value here should be both 100%. Seems your caliration was not successful.
Try more and I'l ...

It was more a matter that the person holding the sticks didn't apply sufficient pressure. They both go to 100%...I just didn't have enough hands.

pete1144@me.com Posted at 2015-1-27 10:41
It was more a matter that the person holding the sticks didn't apply sufficient pressure. They bot ...

Uhhh...Weird and no idea yet...Now I think we need a log for analysis.
Send a mail to me >> autumn.a@dji.com with the post link, I'll reply with the method to access the log.
Then power up your aircraft, pull the sticks in CSC position, then power off. Send me the log of that process.