I calibrated my radio last night using the Phantom RC software, I noticed there was on upgrade available. - I am using a old style 2.4Ghz DJ6 controller with a zenmuse hd-3d. Afer the upgrade the light on the from panel now turns to green NOT red as it always had. All channels expect the X1 channel for the gimbal are working. The X1 is responding in both the Phantom 2 (in Naza mode) and the RC software, only that it is not moving the gimal. The gimbal is fine, actually changing the limits, and re powering the phantom adjusts the limits. I've tried lots of times to recalibrate, but there is still no response. I am guessining that the change in the led light on controller is an indication of the problem but I cant after lots of searching find any solutions.... Any advice much appriceted.

I calibrated my radio last night using the Phantom RC software, I noticed there was on upgrade available. - I am using a old style 2.4Ghz DJ6 controller with a zenmuse hd-3d. Afer the upgrade the light on the from panel now turns to green NOT red as it always had. All channels expect the X1 channel for the gimbal are working. The X1 is responding in both the Phantom 2 (in Naza mode) and the RC software, only that it is not moving the gimal. The gimbal is fine, actually changing the limits, and re powering the phantom adjusts the limits. I've tried lots of times to recalibrate, but there is still no response. I am guessining that the change in the led light on controller is an indication of the problem but I cant after lots of searching find any solutions.... Any advice much appriceted.