Please select Into the mobile phone version | Continue to access the computer ver.
Motors stop on just one stick
452 2 2016-6-5
Uploading and Loding Picture ...(0/1)
o(^-^)o
jandmlea
lvl.1

Australia
Offline

I've noticed since up-grading to the latest firware V1.8.0 the motors cut when i just pull the throttle stick back (rather that pushing both sticks down and centre). Has anyone else experienced this.  I'm a mode 1 flyer. So,  with the motors running I pull back on the right stick and after a few seconds (2-3) the motors quit.  I did wonder if the aircraft could tell it was stationary, but having picked the aircraft up and tried to apply a sence of movement the motor still stopped when i pulled thethrottle stick back.

Any ideas?  Does anyone elses Inspire do this?
2016-6-5
Use props
Donnie
Captain
Flight distance : 3636782 ft
United States
Offline

It has always done this , the aircraft knows when it is on the ground, also this is the best way to stop the motors or else a tip over can sometimes occur when doing the Combined Stick Command while on the ground. Mode 1 or 2 is the same.  Also it will not do it in the air, so no worries . The sensors all must agree the craft is on the ground )  

Donnie

2016-6-5
Use props
Zbounce
Second Officer
Flight distance : 181125 ft
United States
Offline

1 stick has always been there at least as far back as I go.
2016-6-5
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules