Hello everybody,

I want to link a Phantom 3 Remote Controller (Model: GL300B) as slave to my Matrice100 - using the M100 RC (Model: GL658A) as master.

Does anybody know if that should work?
I tried linkin the Phantom 3 RC to my Matrice but that failed so far.

Greets, Markus

The P3 RC could not be used as a slave remote, as it does not have the built in 5.8 GHz frequency. It may work as a Master remote, but it's recommended to use an Inspire 1 RC with the M100 series due to being interchangeable as a Master/Slave.