Hi, I tried to reset my Zenmuse H3-3D gimbal by shorting it out to fix it being unlevel from a recent crash. I didn't realize I shouldn't turn off the Phantom after shorting out the gimbal. Now when I turn it on I have a green light instead of a red one, which would allow me to reinstall the firmware via the Assistant software. According to the tutorial below, if you still have a green light just run through the process again. I did multiple times, but I still have a green light. The gimbal/firmware isn't showing up in the Assistant Software at all. Help!
We're youable to solve this issue? I've runninto a similar situation but I have a stand-alone H3-3D that uses a GCU and I can't find an older version of the Zenmuse Assistant Software to downgrade the firmware to 1.12