Hi all
can somebody explain me, how to configure the m600 with ronin mx for dual Operator Setup? I know there's a remote coming with the ronin, but I'm talking about a professional solution were the cam Operator also can connect the iPad and control the Settings of the cam...
Thanks in advance!

Hello.
In Matrice 600, the ground station of the Lightbright 2 can control the aerial platform and the Ronin-MX. In the DJI GO App, you can set the Dual Operator mode. In the App, it can also control the camera's Shutter and Record.

Thanks.

DJI-Adela Posted at 2016-6-23 10:20
Hello.
In Matrice 600, the ground station of the Lightbright 2 can control the aerial platform and t ...

Thank you adela, but how it can be controled via a second Operator? He Needs also a RC Transmitter to control the cam (Pan/Tilt, etc)
Can I use a Inspire RC for that?

Heliflo Posted at 2016-6-23 17:32
Thank you adela, but how it can be controled via a second Operator? He Needs also a RC Transmitter ...

Hello.
In Dual Remote Controllers Mode, the Slave Remote Controller can set to control the gimbal in the DJI GO App.
The Inspire RC is not compatible with the LB2.

Thanks.

Heliflo Posted at 2016-6-23 17:32
Thank you adela, but how it can be controled via a second Operator? He Needs also a RC Transmitter ...

Just to clarify Adela's last post, because the M600 uses Lightbridge 2, you would need to get another Lightbridge 2 RC and pair that as a slave.

DJI-Jamie Posted at 2016-6-23 19:37
Just to clarify Adela's last post, because the M600 uses Lightbridge 2, you would need to get anot ...

that brought it to the Point for me...thanks

Heliflo Posted at 2016-6-23 14:16
that brought it to the Point for me...thanks

Hi - I have an lb2 remote, slaved to the master remote, however I cannot get it to control the Ronin MX. Did you work it out?