I need to install two battery comparments and a Zenmuse X5 Mounting Base at the same time in Matrice 100, according to our technician the batteries compartments must be placed at the top of the Drone, and i have seen pictures of Matrice 100 with on battery and the X5 in the below part, and only one battery in the top part, can i get some help?

Thanks in advance!

Leo

That may have been done with 3rd party modification. The issue is that the Mounting base for the X5 on a M100 takes up most of the space underneath and would not allow a battery or an expansion bay to sit properly. The weight of those components would go past the max take off weight and could cause inefficient flight.

DJI-Jamie Posted at 2016-6-24 18:20
That may have been done with 3rd party modification. The issue is that the Mounting base for the X5  ...

I understand Jamie, but even though i have that X5 mounting base, i will only use an XT, its still not possible to use both batteries?

i will attach a picture that someone referred me in facebook, maybe it could work...

Thanks in advance!

LEO MARTINEZ HELLO, I want to know how flies with two batteries and x5?
It works 100% or the load is too heavy? Thank you

I have installed both battery trays with TB47D with X5 gimbal/camera setup at 3800 grams (200 grams more than recommended AUW). No lack of power, efficiency, or flight time (noticeable).

dronefilms Posted at 2016-7-4 20:30
LEO MARTINEZ HELLO, I want to know how flies with two batteries and x5?
It works 100% or the load is ...

I couldnt assemble two batteries and an X5...

jared@geobluser Posted at 2016-7-23 13:54
I have installed both battery trays with TB47D with X5 gimbal/camera setup at 3800 grams (200 grams  ...

Could you send me pictures of your setup, i couldnt do it, and i need to fly two simultaneous batteries and an X5, thanks in advance.

jared@geobluser Posted at 2016-7-23 09:54
I have installed both battery trays with TB47D with X5 gimbal/camera setup at 3800 grams (200 grams more than recommended AUW). No lack of power, efficiency, or flight time (noticeable).

Interesting inputs. Moving in your configuration.
By the way, did you change any Gain or Attitude values ? DJI Go propose to change these advanced parameter between 70-130%. Any recommendation ?

I have the same setup as the one in the photo.  I have been flying it that way for 8+ months with no issue.  I have 2 batteries on top with a X5 plate below and a Z3 camera.  I also carry a FLIR Vue Pro and batter pack on occasion.  I have never had any issues.  I had to drill a few small holes into the top rail to make it work but it runs fine.  I can easily get up to 40+mph, my top speed with this configuration is 55mph.