hazardPRO
 lvl.2
Offline
|
Hi all, hoping someone can help?
I building up a hexcopter using WKM, Lightbridge, Futaba TX.
I need a channel to operate a servo (for a custom hatch/door release) and I cant work out how to hook it up. I know you can assign channels in Lightbridge, but not sure where to hook up the servo on WHM
X2 is being used for Lightbridge, that leaves X3 but not sure if that can be used for the servo? Or perhaps F1 or F2?
I read something about using a 'SBUS expander' (http://forum.dji.com/thread-3252-1-1.html) on the X2 port, then pluggig Lightbidge and the servo into the expander?
Or maybe a 'sbus decoder'? But again not sure how one would wire that up? :/
Any help would be very gratefully received!
Thanks
Paul
|
|