Please select Into the mobile phone version | Continue to access the computer ver.
Gimbal cannot recieve Main Controller data
1018 7 2016-7-5
Uploading and Loding Picture ...(0/1)
o(^-^)o
remko.ehrhardt
New

Netherlands
Offline

Hi,

I just bought the Inspire 1 v2, and although I havent used it in air... after the firmware update I:

Cannot caliberate anymore (compass)
Gimbal cannot recieve Main Controller data
Command times out
The light at the back is going insane

Before this he did caliberate but kept on saying there was a IMU error
Was so looking forward to this.. Anyone has any ideas?

Oh one more thing, it says:
Check the 8 pin plug that connects the damping plate and the aircraft. Ensure that none of the pins are loose. If the problem persists, contact DJI Support.
I checked that, and its pretty solid

Thank you

IMG_7322.PNG
2016-7-5
Use props
Donnie
Captain
Flight distance : 3636782 ft
United States
Offline

I would try a IMU full calibration and a Camera Gimbale calibration , I have seen this once before and it was right after an update.  Worth a Shot.
You do have the update completed for the RC and the Aircraft corrrect , always make sure to update the Aircraft first.....  ALWAYS .  
Be sure to reboot the whole system as well,  Aircraft , RC transmitter , Go app.  Start fresh for the Imu cal and Gimbal Cal.

Version 1.6 on the Transmitter and 1.8 or 1.9 on the Aircraft correct ?  This is what you have loaded ?
The last thing to do will be the compass calibration outside in a wide open area, keep the tranmitter 10 feet away as well, dont worry about this till flight time .

Do it in the order I have specified

donnie


2016-7-5
Use props
remko.ehrhardt
New

Netherlands
Offline

Donnie Posted at 2016-7-5 19:24
I would try a IMU full calibration and a Camera Gimbale calibration , I have seen this once before a ...

hey Donnie

it actually worked
thank you so much!
2016-7-5
Use props
DJI-Jamie
DJI team
Flight distance : 112405 ft
United States
Offline

remko.ehrhardt Posted at 2016-7-6 02:52
hey Donnie

it actually worked

Good to hear you got yourself up and running.
2016-7-5
Use props
Donnie
Captain
Flight distance : 3636782 ft
United States
Offline

remko.ehrhardt Posted at 2016-7-5 13:52
hey Donnie

it actually worked

Your welcome, I had seen that happen to another member and that is what we came up with to fix theirs, so happy you have it working.

donnie
2016-7-5
Use props
Donnie
Captain
Flight distance : 3636782 ft
United States
Offline

The strange part on this when I first saw it was to check the Pins and connectors.  Such a strange message and a simple fix.....................once you know what to do .

Once again, good job- glad you are up and flying

donnie
2016-7-8
Use props
=AKA= Golgo13
lvl.1
United States
Offline

After Firmware update

Ok I have the same issue and have tried what has been suggested but I have not been successful. The drone boots up the gimbal twits and turns then stops and drops to one side and just beeps. Any further ideas?

Gimbal cannot recieve Main Controller data
Main Controller
IMU
Barometer not calibrated


10-8 21:53
Use props
ro_walker
First Officer

Brazil
Offline

Interesting...  so where does the sky high price tag come from???
11-8 16:28
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules