I am installing the Lightbridge 2 to a S900 recently purchased which was half built. Everything makes perfect sense apart from the gimbal cable. The Z15 gimbal on the S900 has a jack socket not a 7 pin connecttion.... How do I connect the gimbal to the lightbridge?
It is unfortunate, I apologize for the inconventience. This information was also available in the Specs section of both the Lightbridge 2's product page and manual.
When using Lightbridge 1 with the iOSD Mark II, there would still be redundancies in OSD information, but you can still use the Mark II to record flight data for future analysis. You can still have them connected to the same rig without issue.
Hello!
I have Lightbridge2 installed with A2 on S1000+, unfortunately does LB2 Flight Unit not .. it lights up none of the two LEDs.
The following cables are connected:
- Gimbal cable, but without Gimbal
- CAN cable on CAN-distributor to A2 >terminal Can2
- Dbus cable A2> terminal X2
What could be wrong here, or is missing something?
Why are white and black antennas here with?
The air unit gets its power from the DBus connection. Could you clarify whether the unit is supposed to be on in these pictures? Unfortunately the computer image is not clear, what error message are you receiving in the Assistant Software? Is this your first time putting this unit together, or are you just upgrading your FPV system?
No, that can not be right.
I have found that the power supply via the gimbal done. After I installed no Gimbal, there is no electricity. Is not well constructed :-(