I fly an Inspire Pro with dual remotes. One controller with Ipad air and the other using an Iphone 6. The ipad does just fine but the iphones video signal cuts in and out and is not usable. Starts happening not even 10meters away. Is this a problem that occurs with the iphones or the remotes?

The  phone may not have enough processing power for the Pro , If the I Pad works well on both the slave and Master it is more than likely the phone or maybe the cable.

My bet is the phone.

donnie

Hello Inspired68, when you set the current slave RC to the master RC with iphone 6, does the same issue happen ? What's the quality of the live feed when you use the iphone 6 on your current master RC?

DJI-Paladin Posted at 2016-7-20 01:46
Hello Inspired68, when you set the current slave RC to the master RC with iphone 6, does the same is ...

You're suggesting to set my current master RC to be my slave RC and then use the Iphone with the new master?

Donnie Posted at 2016-7-19 15:55
The  phone may not have enough processing power for the Pro , If the I Pad works well on both the sl ...

I have been told it can be the cable, but when using that cable with the Ipad its not a problem. Would a higher gauge wire help the iphone with processing speeds ?

Inspired68 Posted at 2016-7-20 10:52
I have been told it can be the cable, but when using that cable with the Ipad its not a problem. W ...

If it works with the I pad , then thats not the problem.  It is the Phone in my opinion

Make sure you are not running any apps in the background on I phone  and enable " Hardware decode" on the go app to take some of the strain off the phones processor .  It is located on the go app.

see if that helps.

donnie

Inspired68 Posted at 2016-7-20 23:50
You're suggesting to set my current master RC to be my slave RC and then use the Iphone with the n ...

Yes. Also before changing the master/slave RC, you can use your iPhone 6 instead of your iPad on your current master RC to give it a try.