Can anyone confirm if these are the correct or Latest firmwares according too the APP while stationary on ground?
Strangely enough remote says "Safe too fly" atti mode, It tells me all's fine...But that there is an abnormal update
Please...Thank You.

APP               1.0.4
Main Controler        Firmware:01.15   Loader:34.01
Camera                       Firmware:01.03   Loader:00.00
Gimbal                    Firmware:01.05   Loader:01.00
Center Board           Firmware:02.03   Loader:03.00
Remote Controller   Firmware:01.04   Loader:02.00
Battery                    Firmware:03.00   Loader:02.06
Air OFDM                 Firmware:01.03   Loader:03.00
Air Encoder              Firmware:01.10   Loader:01.00
Ground Encoder       Firmware:01.03   Loader:01.00

CO
That's what Im seeing in the about data as well,  all values match.

CO
That's what Im seeing in the about data as well,  all values match.

Thank You

Ur welcome Suh Safe flying!

Please confirm, the remote controller  value is 1.03 or 1.04?

my Tx states  firmware 01.03  hmmmmm.

My TX firmware 0.103

same here.

Here is s screen capture of the Firmware's on my device's

I'm guessing that the *Build Date* of your craft / Controller may have an effect on the versionor like me the seemingly unabilitytoo update the TX....Could this be right? as the latest version would already be set

Inside the case your bird was in should be a small cardboard notice stamped  PASS 2015-01-14    DJI QA* << this is mine anyway.

I wonder if it is set by Region like I'm in Australia so may need a slight diff in TX versions