Hi,

I jus got my P3P back after sending in for warranty on cracked shell. However after receiving the drone back i noticed that a few things,
1.) the motors are not all straight, it is somehow tilted at an angle.
2.) after i install the propeller and when i start the motors, i notice the propeller are not as flat as before, besides that some show double edge (at the end of the propeller when the motor starts)

Is this normal ? I yet to take the drone to test it out as i am afraid it might fail etc.

I tried to take photo of the condition but its hard for the photo to show.

Regards,
KW

The rotors are tilted to stabilize the decent phase if you get in a hurry to get down.

Yeah, agree with AG0N-Gary. The motors are like that to prevent VRS.

As for your second observation, are you saying that one blade is higher/lower than the other blade? Since we can't determine the actual condition of your props, when in doubt, just replace them with DJI props.

KW, normally the motors are tilted at a small angle. Before we sent back the drone to you, we would arrange flight test for your drone to ensure its performance. So you don't need to worry about that.

Hi DJI Paladin,

so i would assume its good to fly after i receive ? or do better to recommend to recalibrate the IMU, gimbal and compass all ?

Regards,
KW