Hi I just bought me a Inspire 1 Pro with an extra remote. I previously had a Inspire 1 (X3), which I was really happy with, but would like the better camera. I have flown a bit with it, but now I have several times tried to link the extra remote to the master, so I can use the ekstra remote for camera/gimbal control. My master remote is set to "master" and I can see my slave remote has full signal under "slave remote list". My slave remote is set to "slave" but I have to search for the master controller every time I start it up. When I do that, the master apears, and I click on it. Nothing happens when I move the sticks on the slave remote, but I´m allowed to take pictures with the button. There are god picture signal and they all have the latest firmware. I've noticed that when I will setup gimbal stick, so I go into custom and change it. When I press save, I get this message "Warning. Channel not Defined". However it does not change the lack of control, because it’s the same has it in defauld stick mode.
|