djiuser_wiHdqiUGCmQN
lvl.1
Canada
Offline
|
Hello not sure if the thread is still going, but I found the same issue on my p4 I did my own self trouble shooting by trying to isolate the issue. Below are a brief overview of the steps I look. ( I only had this issue with 1 black prop motor)
1. With spinning motor with prop on as is would wind down I would notice the same sound as the video shows.
2. With spinning the motor by hand with prop off I never got the same sound even listening right beside I didn’t suspect it was an issue.
3. Hand spinning each motor and feeling resistance and if any grinding (I closed my eyes and did this with much concentration) and still all felt basically the same.
4. Felt the prop on in hand and took apart the quick release, cleaned and inspected it. All was good.
I then noticed all the tabs that push up on the prop some were low compared to other motors.
With no damage noticed I proceeded too put everything back together but I lifted the tabs slightly. Spun the prop on and no sound! Good luck |
|