Anyone expericance latency issues with an M100? Ive been testing an X3 and have also seen this using an XT thermal camera. Getting choppy image signals.

Is this right after set up, or did this occur after a firmware update? Have you had any hard landings? Could you please provide a list of what you have installed on your M100? Are you using the DJI Go app and if so, what mobile device are you using?

This is right after setup, flys 100% perfect, just having some intermittent latency issues. It will kind of flash/stutter on the screen. I did notice that when viewing the channels most were red if that helps?

Matrice 100, dual battery, guidance, X5 adapter (capable). This was with an X3 and XT attached.

phil@toledoaeri Posted at 2016-9-8 20:36
This is right after setup, flys 100% perfect, just having some intermittent latency issues. It will  ...

Could you clarify if you are using the DJI Go app or a SDK application? If you are using the GO app, what mobile device do you use with it? Do you use the latest software and firmware?

DJI-Jamie Posted at 2016-9-8 18:39
Could you clarify if you are using the DJI Go app or a SDK application? If you are using the GO ap ...

Hello, yes the DJI Go app and it was with a iPhone 6+ on the latest firmware

phil@toledoaeri Posted at 2016-9-12 22:28
Hello, yes the DJI Go app and it was with a iPhone 6+ on the latest firmware

And you do not use any SDK, correct? Have you tried using an Android device to see if it's an issue with the iOS version of the Go app?

DJI-Jamie Posted at 2016-9-12 12:51
And you do not use any SDK, correct? Have you tried using an Android device to see if it's an issu ...

Correct, I haven't used any SDK. No I haven't tried on an android device.

phil@toledoaeri Posted at 2016-9-13 03:46
Correct, I haven't used any SDK. No I haven't tried on an android device.

Please try an Android device and let me know if the issue persists. It would help rule out an iOS issue.