KWJC
lvl.1
Canada
Offline
|
Hey everyone, I received my Osmo Mobile today, charged the battery, activated the unit, and was hoping to just start playing with it. Unfortunately the DJI Go app kept telling me to attach my phone even though it was already attached. I took the case off the phone and tried again without the case but with no luck, same message to attach my phone... so instead of my Sony Z5, I tried my old Nexus 5 phone with and without its case, both times also getting the same message about attaching my phone... frustrated by this point... Finally, the only way I could get the Osmo Mobile to work was to put electrical tape over the Mobile Phone Detection Sensor. Once I did that it worked fine and I was able to start playing with it. Hoping that DJI releases a firmware update that would allow us to turn that sensor off seeing as how it doesn't work 100% anyway, sounds like a better solution than covering it up with electrical tape.
So the reason I am posting this is for anyone else who runs into this issue and gets frustrated with their Mobile right out of the box, if you have this problem, a little bit of tape over the mobile phone detection sensor will make it work.
|
|