Hello.  With Inspire 1 RAW with dual remotes, can you also operate the camera in a mode similar to Phantom 4, using only 1 operator when needed?  In other words, do you have to always have two ops?

Thanks in advance.  

Yes you can operate the camera using the gimbal wheel on the left side of RC. Two ops not required.

You can also use other apps to either control flight or the camera. Litchi and Autoflight Logic are good for this, essentially they are AI secondary operators. Worth looking at.

Regards
Mark G.

You are able to use the Inspire 1 Raw as a single operator and still have some gimbal control.

Yes you can but the tilt/pan will both be adjusted by the tilt wheel. So unlike the 2nd RC where you can control both pan/tilt at the same time, with only using the master you can only move one at a time and switch between the two from the C button.

DJI-Ken Posted at 2016-9-26 20:45
Yes you can but the tilt/pan will both be adjusted by the tilt wheel. So unlike the 2nd RC where you ...

But you CAN control the tilt with the wheel AND the pan with "yaw" Both at the same time IF you got the Cojones!

Jus' sayin'

Mark G.

markaguille Posted at 2016-9-28 03:30
But you CAN control the tilt with the wheel AND the pan with "yaw" Both at the same time IF you go ...

A steady hand does go a long way. Performing a yaw maneuver while tilting is feasible with minimal stress, especially if you plan to chase the subject anyway.

Thanks all. Very helpful!