I have upgraded all software on Phamtom Vision  plus v3 including cameraI have upgraded software on Mac

Everything seems to be ok - with one rather large issue remaining

The camera boots ok, and takes video or photos on I get a green flashng light, but it will not respond to either to transmitter wheel or to my iphone (6) - which it used to do. The servo is working fine as it corrects when I change angle of phantom in all directions , but wont respond to rotate  up /down  calls


Am I missing something I should have done, as it was fine before upgrade.

Any help/steerance  apprecaited

James

Do this stand alone calibration for the camera control wheel

Gerry1124 Posted at 2015-2-1 18:52
Do this stand alone calibration for the camera control wheel

Thank you very much  - The process worked fine ,and transmitter is definitely calibrated ok
However - the camera will still not respond - which suggests the problem is on the Phantom
very frustrating !

Thank you for your help - every step forward is good

I also can not calibrate the gimbal. I'm doing the activities mentioned or first rc vision assistant and later assistant and plug the Phantom and gimbal runs until the cable connection. How to remove the cable and restart the gimbal do not work. From purchase gimbal I worked two days and stopped working. Sometimes the fifth turning gimbal later works and does not work again. What to do ??
And here's a video of the calibration