Hi folks,

Quick question as I cannot find the answer googling it...I am wanting to purchase a P3P, that comes with a mobile device holder. This holder I am not familiar with, as I currently only own a P3S.
I know it has a max width of 170mm, but what's the minimum width before it stops retracting?
I'd like to ensure it will accept my S7 Edge of 72.6mm (once I've sorted my firmware downgrade issue), or any similar sized smartphone.

Thank you for your help.

Yorick

Your good to go with the S7  Edge the smallest i've ever used is a S2 on the larger scale you can just about fit a   samsung 10.5 tabs S. I believe there is device holder extension available also.

pi-inthesky@hot Posted at 2016-10-3 22:45
Your good to go with the S7  Edge the smallest i've ever used is a S2 on the larger scale you can ju ...

Thank you very much for your reply.

yoricknicholls Posted at 2016-10-3 20:26
Thank you very much for your reply.

My pleasure

As a point of reference, the max size that the device holder can hold at stock is an iPad Air 2. Like pi-inthesky mentioned, there some 3rd party extensions that are out there but you want to be careful with having too much weight on it.

DJI-Jamie Posted at 2016-10-5 05:54
As a point of reference, the max size that the device holder can hold at stock is an iPad Air 2. Lik ...

The max size isn't my worry, it's the minimum size when the holder isn't extended. It must hold the S7 Edge (72mm) firmly, and not be too wide for it.

yoricknicholls Posted at 2016-10-5 04:35
The max size isn't my worry, it's the minimum size when the holder isn't extended. It must hold th ...

There are retractable hooks along the side of the device holder that would be able to accomodate nicely.

I'm using Nexus 5X and could still fit a lot narrower device...

Thank you folks

You're welcome, best of luck to you with your next aircraft.