jamesnns
lvl.3
United States
Offline
|
Make SURE you're using the correct app. Its the FC40 app, not the other Vision apps. The camera does NOT connect to the FC40 in any way at all. Its a simple Wifi connection between camera and device...thats ALL.
Charge camera using the same gray micro usb cord that you use for your Phantom
Put SD card in correctly
Turn camera on
Wait 30 seconds
Go to your tablet or phones WiFi settings.
Click connect on the dji-xxxx Wifi signal
Wait until the tablet or phone is connected
Start FC 40 app on device.
The app will show the dji-xxxx Wifi signal
Click it
If it doesnt connect, close app and try again. Do not restart the camera. (The app has a habit of remembering the last FC40 Wifi connection so sometimes you need to restart the app to connect each time)
Once connected, click FORMAT via the app. This formats your SD card for vid and pics.
Done.
Use the same usb for charging to transfer your vids/pics top your PC. No need to remove SD card if you dont want.
or, with the camera still on and the app running you can transfer to your device with-in the app itself. |
|