Hello I have the inspire V2 with the X5 camera and I’m getting a warning that the firmware needs to updated, but I can not find what it is that needs to be updated.  I also still have the X3 camera that I use occasionally.

Here’s what the GO APP says I currently have for firmware


App 3.0
Aircraft 1.9.1.30+
Remote 1.6.0
Camera 1.9.1.10


If there is an update is this an update I want to do or are there bugs?



Mark

When you look at the upgrade notification, does it mention which component? Just to make sure that the data is reading correctly, have you tried reinstalling the Go app?

Your RC transmitter will work with 1.6 but 1.7 is the most current.  It will usually say on the system status page of the go app what needs updating.  ( odd if yours is not, screen shot perhaps ?   )  Personally have better luck with 1.8 on my aircraft ( You could downgrade to it, it is up to you )  You will get a warning but the system works better with 1.8 on the RC and Camera and 1.6 on the RC.

Just a opinion that I think many share here .

donnie

As Donnie said, 1.7 is the most current firmware for the RC, but your app should specify the RC.