Newest firmware on all modules. Its really weird when you try to calibrate the sticks the blue bar follows the stick to the left and then when you go to right it shows movement back on the left. This is the same on both my lightbridge 2 groundstations. No matter what all the same result locked out of flight. Any one else have this? I work for hrs on this trying everything resets, swap controllers, reinstalling all go apps IOS and Android and PC assistant 2. I had now issues calibrating IMU like others used two bubble levels mounted on top plate makes it a lot easier.

S900
A3
LB2
Z3

Could you verify what firmware you have on the A3 and LB2? What Assistant 2 Software version do you have?

assistant v 1.0.6
A3 1.5.0.00
lightbridge v 1.1.30

I have since

I have rolled back the firmware to 1.3.0.00 and am know using assistant version 1.0.5 and got stick calibration back again and  ,But the IMU took at least five minus to calibrate. haven't flown yet.     

OK.... does this mean with the new firmware for the ground station released today I should upgrade the A3 back up to 1.5.0.00? its getting to be bit annoying I cant go out in the field without my laptop... but this is kind of how its always been though

I mean lightbridge ground end not data link grounstation just so there is no confusion

Just wanted to give a update flew twice now and the s900 is solid as a rock in flight. Yesterday there was a steady 5-10mph wind and did pretty good.