Been having problems getting my I1 to upgrade firmware. Basically it fails:
http://spark6.d.pr/1aQkg


Took a look in the log files and noticed the following (highlighted in red):

[00004177]Packet [C:\WM610_FW_V01.02.00.16.bin] detected.
[00004228]Packet upgrade start...

[00004242]Packet checking...
[00004247]Done.

[00004256]Version checking[1]...
[00004263][01 00] v1.3.1993 -> v1.3.1993
[00004315][03 05] v34.1.0.5 -> v34.1.0.5
[00006322][03 06] v1.15.4.9 -> v1.15.4.9
[00006334][04 00] v1.5.0.61 -> v1.5.0.61
[00006360][05 00] v2.3.6.0 -> v2.3.6.0
[00018868][08 00] device not detected.
[00018884][09 00] v1.3.6.3 -> v1.3.6.3
[00018919][11 00] v3.0.0.11 -> v3.0.0.11
[00018979][12 00] v1.3.0.60 -> v1.3.0.60
[00019039][12 01] v1.3.0.60 -> v1.3.0.60
[00019099][12 02] v1.3.0.60 -> v1.3.0.60
[00019159][12 03] v1.3.0.60 -> v1.3.0.60
[00031668][15 00] device not detected.
[00031697][17 00] v1.0.2.4 -> v1.0.2.4
[00031777][17 01] v1.0.0.9 -> v1.0.0.9
[00031797][19 00] v1.0.8.3 -> v1.0.8.3
[00031805]Packet upgrade failed at version checking.




What this results in is the lightbridge video feed failing after about 30 seconds and turning into a gray feed. The camera is unresponsive after that.

Any thoughts?

all i have to offer is that i have had to set my channel manually instead of auto..no more lost signal on the master..but the slave loses it still.

@s.s.gibbs1.emai - turns out my Inspire1 was DOA. The gimbal refused to update firmware. It is back in DJI's hands now as it was returned under RMA. Judging by the lack of responses I think it is safe to assume that my issue was an anomaly. I don't want to scare off any prospective buyers.