Hi,

Can you pass on some info to DJI so they can address!

Most A3 users want functionality of the A2 w/ hardware of A3

Simple firmware fixes:
- arming: motor time out (like Wooking, where if you arm it and don't touch the throttle is disarms after a few seconds), right now is very damgerous!
- gains: make max gains higher then 150 (200 would be good)

Hardware fixes
- Bluetooth LED w/ lights you can actually see (really annoying to have  to use a computer to adjust "for those not using lightbridge which is most of your customer base")

Basic flight questions
- A3 Pro toilet bowls / drifts like 10ft when stopping, redid the compass - what else can be done about this?

Thx, Jason                

Could you please provide a list of your set up? Could you verify what firmware your currently running on the A3?

DJI-Jamie Posted at 2016-11-10 15:02
Could you please provide a list of your set up? Could you verify what firmware your currently runnin ...

F.C. = A3 Pro (confirmed COG offsets)
F.W. = 1.5
Assistant = 1.06
O.S. = Windows 8
Motors = KDE 5215 / 435
ESC = KDE 95amp
Props = 18"
Drone = X8
Radio = Futaba 14SG S-bus
Batteries = 2x 22,000 Tattu PLus
Weight = 45lbs w/ payload

PS - also make it that you can hit a SAVE button in the Assistant App.
I just opened up the assistant app to verify things before another test flight and noticed the GPS settings where back to defualt? (so there is a save bug in the new version 1.5)?

Adding to this list...

Today the A3 flew but once we swapped batteries this error came up!

GPS disconnect; please disconnect and check connection.

Rebooted, same issue, rebooted again and issue went away.

This needs to be addressed ASAP, no reason a flight controller should do this.

And yes everything is plugged in correctly, nothing changed from the previous flight.

Hello DJI any word! Anyone there?

Daily bump till DJI fixes the A3 &A3 Pro!

daily bump

what are the typical mounting values for the A3 system when using an S900 with a bmpcc gimbal? regular A3 not pro.