Hi, Just like to say thanks for all the help out there.
I have had to replace my 5.8ghz receiver board on the P2V+ due to a slight error in a modification.
Now I have no contact from RX to TX I have tried pressing the bind button on the Phantom and placing the throttle down on the receiver but no bind. I am wondering if I have a faulty board? last resort replace it!
PLEASE HELP MY DRONE FIND AIR SPACE!!!!

The way you bind the transmitter to the Phantom is
turn your transmitter off,  press the little red light on the underside of the Phantom until it flashes yellow then turn on your transmitter, the light should go out and you will be paired with it.   It is all in the manual.

Hi, I will give it a shot and get back to you shortly
thanks for the help

orlando.tony.gm Posted at 2015-2-11 00:52
Hi, I will give it a shot and get back to you shortly
thanks for the help

Please remove the props if you are inside and just testing it.  Do not start them with the props on.

orlando.tony.gm Posted at 2015-2-11 00:52
Hi, I will give it a shot and get back to you shortly
thanks for the help

Hi Gerry,
    I don't know what I done different but it worked I also was able to recalibrate.
Thank a million I really appreciate it
Until next time

orlando.tony.gm Posted at 2015-2-11 01:00
Hi Gerry,
    I don't know what I done different but it worked I also was able to recalibrate.
Tha ...

Good to hear
Happy Flying!