Donnie *
First Officer
Flight distance : 3636782 ft
United States
Offline
|
Farmer10 Posted at 2017-9-13 04:50
I haven't had time to work with my drone since the last part of this conversation. I now have two controllers. One is brand new, the other is the old one. I should preclude this with the fact that I had my drone sent into DJI for service and it has not worked since. I cannot get EITHER controller to take the inspire out of travel mode even with a blue light on the aircraft and a green connected light on the controller. Neither controller will connect to my DJI Go app either, I have used multiple cables. I manually took the aircraft out of travel mode with the set screw, connected the camera and the camera won't connect to the inspire either. I have reset both controllers and reconnected to aircraft with no luck, I have put new firmware in the camera and obviously since it won't connect to aircraft that did not work either. I am not quite frustrated. When I connect EITHER controller to the DJI go app and press down on the upper right hand button to show current firmware etc it shows that it is disconnected......I'm guessing I have multiple versions of firmwares and maybe both controllers are set to too old of a firmware to be able to connect to the DJI app at all and therefore that is why even though they are connected it won't take it out of travel mode?
I dont understand how you sent your system to DJI and It came back NOT working ???? Did you send the Entire unit in ??? dont get that part .
*****Before you do anything, take the transmitter with the Green light, this indicates that your AC and RC are communicating , then cycle the landing gear switch 4 times quickly , this should take the AC out of travel mode , make sure camera is off. ( Aircraft is on of course ) Go app does not have to be on or even connected to the Rc for now.
Now once you do this , let me know if you can get this to work .
I think what we have here is the AC and the RC are linked, as indicated by the Green light on the RC. But you are in Travel mode and cant get out of this via the Go app BECAUSE EITHER THERE IS A BAD CABLE OR THE MODULE ON BACK OF THE RC IS TOAST.
anyway , get it out of travel mode and we will go from there . Make sure you cycle 4 times quickly with the landing gear switch .
*** dont get the New RC involved just yet
donnie
|
|