htieK
lvl.1
United States
Offline
|
I have a Matrice 100 with two battery compartments; one above the center frame and the other below the center frame. The aircraft firmware is at version 1.3.100, the GO App is at version 2.9.2, the RC is at version 1.7.4.0. A TB48D battery is loaded in each compartment. Both battery cables are connected to their XT60 plugs. The top battery is started first and after a few seconds the aircraft binds to the RC. Then, the bottom battery is started. The GO App Status field displays 'Normal'.
However, the second battery is not acknowledged or displayed by the GO App anywhere --that I have found. It is not on the Aircraft Battery screen. Is that normal behavior? Is the second battery actually going to be used? I expected to see the charge status and other pertinent information about both batteries.
|
|