I just install a new gimbal  and camera on me P3S and I get a disconnect on the app and I 'am at a lost I tried everything and nothing just wont connect ,  does someone know what going on maybe can help please

The wifi radio is part of the gimbal. Maybe if you relink the RC to the AC by using the S2 switch and camera tilt wheel.....

I am new at this could you please tell me how to do it or give me a link so I can read on how to do  it                       TKS I will appreciate very much

Make sure all cables are firmly seated and relink the aircraft and reset the WiFi.
Starting on page 23 are the instructions.

https://dl.djicdn.com/downloads/ ... al_v1.4_en_0112.pdf

I think my wifi is fried it wont link and the cables are ok I re checked  them  TKS for the help

Do you get a wifi signal to connect your phone to at all?

easy1313 Posted at 2016-12-27 07:31
I think my wifi is fried it wont link and the cables are ok I re checked  them  TKS for the help

That most likely is the case, worst case, you would want to consider sending the unit in for service.